Crankshaft Specifications
WARNING: This page is about a different variant/trim than selected.
CRANKSHAFT SPECIFICATIONS
| Item | Specification (mm) |
|---|---|
| Main bearing journal diameter | 57.98-58.0 |
| Out-of-round limit | 0.008 |
| Taper limit | 0.008 per 25.4 (1) |
| Journal runout limit (runout of bearing 2, 3, and 4) | 0.05 |
| Crankshaft end play | 0.100-0.300 |
| Surface finish (RMS) micro | 0.3 |
| Clearance to crankshaft | 0.020-0.065 |
| Thrust bearing journal length | 28.825-28.854 |
| Connecting rod journal length | 28.825-28.854 |
| Out-of-round limit | 0.008 |
| Taper limit | 0.008 per 25.4 (1) |
| Surface limit (RMS) micro | 0.6 rear |
| Surface limit (RMS) micro | 0.9 front |
| Main bearing thrust face surface finish (RMS) micro | 0.6 |
| Main bearing thrust face surface finish (RMS) rear micro | 0.9 |
| Main bearing thrust face surface finish (RMS) front runout limit | 0.025 |
| Runout limit (T.I.R.) | 0.180 |
| Flywheel ring (gear lateral runout (T.I.R.) manual transmission | 1.5 |
| Crankshaft end play | 0.100-0.300 |