Removal and Installation
CAUTION:
Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
NOTE:
When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for the calibration procedures. For module configuration, refer to
MODULE CONFIGURATION
.
- Remove the hydraulic control unit (HCU). For additional information, refer to HYDRAULIC CONTROL UNIT (HCU) .
- Remove the 4 screws and the ABS module.
- To install, tighten to 3 Nm (27 lb-in).
- To install, reverse the removal procedure.