Required Shim Thickness
REQUIRED SHIM THICKNESS
| Type | Input Shaft mm | Output Shaft mm | Differential mm |
|---|---|---|---|
| Measuring shims | 1.00 | 1.00 | 1.10 |
| Determined end float | +0.22 | +0.33 | +0.36 |
| Preload figure | - | +0.13 | +0.33 |
| End float | -0.05 | - | - |
| Required shim thickness | =1.17 | =1.46 | =1.79 |
| Shims available | 1.15-1.71 (in 0.01 mm steps) | 1.31-1.91 (in 0.02 mm steps) | 1.40-2.20 (in 0.05 mm steps) |