Ignition Coil: Service and Repair

IGNITION COIL-ON-PLUG

Exploded View







Removal and Installation
1. Detach the 2 wire harness retainers from the ignition coil stud bolts.
2. Disconnect the 4 ignition coil electrical connectors.

3. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

Remove the 4 stud bolts and the ignition coils.
- To install, tighten to 8 Nm (71 lb-in).

4. To install, reverse the removal procedure.
- Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.