DTC Chart: Front Control/Display Interface Module (FCDIM) - Premium
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to DIAGNOSTIC METHODS for information regarding Ford-specific diagnostic practices.
FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Module: No Sub Type Information | REFER to Diagnostic Routine J . |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | REFER to Diagnostic Routine U . |
| U0256:00 | Lost Communication With Front Controls Interface Module: No Sub Type Information | REFER to Diagnostic Routine K . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | CHECK vehicle service history for recent service actions related to this module. This Diagnostic Trouble Code (DTC) sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT/PERFORM the Programmable Module Installation (PMI) procedure as directed by the scan tool. If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK vehicle service history for recent service actions related to this module. This Diagnostic Trouble Code (DTC) sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT/PERFORM the Programmable Module Installation (PMI) procedure as directed by the scan tool. If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | CHECK vehicle service history for recent service actions related to this module. This Diagnostic Trouble Code (DTC) sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT/PERFORM the Programmable Module Installation (PMI) procedure as directed by the scan tool. If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT 10 seconds. REPEAT the self-test. If Diagnostic Trouble Code (DTC) U3000:41 is still present, INSTALL a new Front Control/Display Interface Module (FCDIM). REFER to Front Control Display Interface Module (FCDIM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT 10 seconds. REPEAT the self-test. If Diagnostic Trouble Code (DTC) U3000:42 is still present, INSTALL a new Front Control/Display Interface Module (FCDIM). REFER to Front Control Display Interface Module (FCDIM) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | REFER to Diagnostic Routine M . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | REFER to Diagnostic Routine N . |