Normal Operation: Notes

With the engine running, the PCM monitors and expects to receive a valid generator monitor (GENMON) signal with a duty cycle greater than 5% and less than 98%. The PCM also monitors the state of the generator command (GENCMD) signal line to make sure it is not stuck high or stuck low. A DTC sets if the GENMON or GENCMD signal fluctuates between out-of-valid range, stuck high, stuck low, or some combination and normal. When the engine speed is greater than approximately 2, 000 RPM, the generator defaults to a steady voltage of approximately 13.5 volts and the PCM sends a request to the Instrument Panel Cluster (IPC) to illuminate the charging system warning indicator lamp.

• DTC P065B (Generator Control Circuit Range/Performance) - The PCM sets this DTC if the input frequency was continuously less than 80 Hz or more than 200 Hz. Additionally, if the signal shows a faulted condition that is happening in a fluctuating manner, the PCM tracks the fluctuations between faulted and normal conditions. This DTC can also set if the fluctuations occur frequently within a short amount of time.

This pinpoint test is intended to diagnose the following: 

• Wiring, terminals or connectors
• Radial arm adapter
• Generator
• PCM