Cruise Control Deactivator Switch: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Do not allow brake fluid to contact the electrical connector. Failure to follow this instruction may result in damage to the electrical connector or wiring.

Install the cruise control deactivator switch.
- Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.
- Tighten to 18 Nm (159 lb-in).
- Connect the electrical connector.
  
  Fig 1: Locating Electrical Connector
  Courtesy of FORD MOTOR CO.
Check the master cylinder fluid level and adjust as necessary.