LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Escape XLS, FWD >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle External Controls >> Removal And Installation >> Gearshift Lever >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Gearshift Lever: Installation

  1. Position the gearshift lever.
  2. Connect the gearshift cables to the gearshift lever.
    Fig 1: Connecting Gearshift Cables To Gearshift Lever
    G06098345Courtesy of FORD MOTOR CO.
    Fig 2: Connecting Gearshift Cable
    G06098346Courtesy of FORD MOTOR CO.
    3. NOTE: Make sure the clips are set completely within the cable adapter groove and fully seated.
    Fig 3: Locating Gearshift Cable Clips
    G06098344Courtesy of FORD MOTOR CO.
  3. Install the 2 gearshift cable clips.
  4. Install the 4 gearshift lever nuts.
    • Tighten to 25 Nm (18 lb-ft).
  5. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
  6. Install the floor console finish panel.
  7. Install the gearshift lever knob and boot assembly.
scientia non olet · About LEMON Manuals