Cruise-Control Module (C-CM): Removal
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If installing a new C-CM
, it is necessary to upload the module configuration information into the scan tool prior to removing the module. This information must be downloaded into the new module after installation.
- If installing a new C-CM , upload the module configuration information from the C-CM into the scan tool by following the scan tool on-screen instructions.
- Remove the front bumper cover. BUMPER SYSTEM
- Gently pry the C-CM
away from the retaining studs.
- Disconnect the electrical connector.
- If required, remove the 3 bolts and the C-CM bracket assembly.
- Inspect the C-CM grommets for any damage and install new grommets as necessary.