Powertrain/Drivetrain Mount Neutralizing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Refer to the ENGINE - 2.0L DURATEC-HE
or ENGINE - 2.0L ECOBOOST
for the specification and procedure for special instructions on loosening and tightening mount fasteners.
- With the vehicle in NEUTRAL, position it on a hoist.
Refer to: JACKING AND LIFTING - OVERVIEW .
- Loosen, but do not remove, the powertrain/drivetrain mount fasteners.
- Lower the vehicle.
- Start the vehicle and move it in forward 0.6 m (1.97 ft) - 1.2 m (3.94 ft). Then move the vehicle in reverse the same distance.
- Raise and support the vehicle.
- Tighten the powertrain/drivetrain mount fasteners.
- Lower the vehicle.
- Test the system for normal operation.
NOTE:
Do not twist or strain the powertrain/drivetrain mounts or damage to the mounts may occur.