Body Control Module (BCM): Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

NOTE: Prior to the replacement of the Body Control Module (BCM), it is necessary to upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new BCM after installation. For additional information, refer to MODULE CONFIGURATION . In the event that As-Built data entry is required (BCM will not communicate), all Integrated Keyhead Transmitters (IKTs) devices must be programmed. A minimum of 2 devices are necessary to complete the configuration and turn off the flashing interior lights.

NOTE: This step is necessary only if the BCM is being replaced.

NOTE: If installing a new BCM , all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.

Upload the module configuration information from the BCM . For additional information, refer to MODULE CONFIGURATION .
Remove the passenger cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
NOTE: The upper 12A581 harness BCM (B+) connector may be more easily removed after the BCM brackets and bolts are removed and the BCM can be positioned lower and away from the body in order for the connector release tangs to be accessed and pressed.

Disconnect the 7 BCM electrical connectors.
Remove the in-line connector wiring harness push pins (2) from the BCM .
Remove the 2 bolts and the BCM .
Remove the BCM front bracket and the 2 BCM brackets from the BCM .