Cruise Control Module (CCM): Removal

WARNING: This page is about a different car, the 2016 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Cruise control module

1.

NOTE: If installing a new CCM, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new CCM after installation.

Using a diagnostic scan tool, begin the PMI process for the CCM following the onscreen instructions.

2.

Remove the front bumper trim panel.

Courtesy of FORD MOTOR COMPANY

3.

Remove the CCM nuts.

Courtesy of FORD MOTOR COMPANY

4.

Remove the CCM.
1. 1.
  
  Release the CCM grommets from the ball studs.
1. 2.
  
  Disconnect the CCM electrical connector.

Courtesy of FORD MOTOR COMPANY

Cruise control module bracket

5.

Remove the front bumper. Refer to: Front Bumper .

6.

Remove the CCM bracket.
1. 1.
  
  Remove the CCM bracket bolts.
1. 2.
  
  Remove the CCM bracket scrivets.

Courtesy of FORD MOTOR COMPANY