April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Flow Chart

SPECIAL TOOLS

G06139341

Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool

Prior to carrying out the flow test, the following items should be checked:

Know and understand the customer concerns.
Verify the concern by operating the vehicle.
Check the transmission fluid level and condition.
Check for non-factory installed items and verify correct installation.
Check the selector lever linkage adjustments.
Check TSBs for vehicle concerns.
Carry out Self Test Key ON Engine OFF (KOEO) and Key ON Engine Running (KOER).
Record all DTCs.

DIAGNOSTIC FLOW CHART

Test	Result	Action
1) Were any DTCs recorded?	Yes	REPAIR all hard DTCs. FOLLOW the pinpoint tests. REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) first, then this Workshop Information.
1) Were any DTCs recorded?	No	REFER to DIAGNOSIS BY SYMPTOM then GO to Step 5.
2) Are any continuous test memory codes present?	Yes	CLEAR codes and CARRY OUT DRIVE CYCLE TEST .
2) Are any continuous test memory codes present?	No	GO to Step 4.
3) Did the continuous test memory codes reappear?	Yes	REPAIR all continuous test memory codes. FOLLOW the pinpoint tests. REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) , then the transaxle reference information, then this Workshop Information, then GO to Step 4.
3) Did the continuous test memory codes reappear?	No	GO to Step 4.
4) Is the concern repaired?	Yes	CARRY OUT the final quick test to verify that no DTCs are present. CLEAR memory codes. RETURN vehicle to customer.
4) Is the concern repaired?	No	REFER to DIAGNOSIS BY SYMPTOM .
5) Are there any electrical concerns?	Yes	CARRY OUT ON-BOARD DIAGNOSTIC (OBD) , then GO to Step 6.
5) Are there any electrical concerns?	No	REFER to the hydraulic and mechanical routine to diagnose and repair the concern, then GO to Step 7.
6) Was the transaxle concern corrected when the scan tool was installed?	Yes	REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) , intermittent fault diagnosis information and use the scan tool to diagnose cause of concern in the processor, vehicle harness or external inputs (sensors or switches).
	No	REFER to the hydraulic and mechanical routine to diagnose the concern, then GO to Step 7.
7) Is the concern repaired?	Yes	CARRY OUT the final Self Test to verify that no DTCs are present. CLEAR memory codes. RETURN the vehicle to the customer.
7) Is the concern repaired?	No	Concern should have been repaired. GO back through the Diagnostic Flow Chart and REVIEW other components that may have contributed to the concern. CHECK and DIAGNOSE those components. GET assistance from other sources.