Adaptive Learning Drive Cycle

WARNING: This page is about a different car, the 2016 Ford Transit-350 HD, 2016 Ford Transit-350, 2016 Ford Transit-250, and 2016 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

Configuration

NOTE: Perform the adaptive learning drive cycle on a level road surface.

NOTE: The engine and transmission must be at normal operating temperature with the transmission fluid at the correct level.

1.

Record then clear the DTCs (Diagnostic Trouble Codes).

2.

Warm the engine and transmission to normal operating temperature.

3.

With the selector lever in (D), moderately accelerate from stop to 80 km/h (50 mph) allowing the transmission to shift into 6th gear. Keep vehicle speed and throttle steady for a minimum of 15 seconds.

4.

With the transmission in 6th gear and maintaining steady speed and throttle, lightly apply and release the brake to operate stoplamps. Maintain the speed and throttle for a minimum of 5 seconds.

5.

Brake to a stop and remain stopped for a minimum of 20 seconds.

6.

Repeat Steps 3 through 5 five times.