July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.

1.
1. 1.
  
  Connect the PCM electrical connectors.
1. 2.
  
  Install the PCM and the retainers.
  Torque: 62 lb.in (7 Nm)

GFD130988

Courtesy of FORD MOTOR COMPANY

2.

Position back the BJB.

GFD130989

Courtesy of FORD MOTOR COMPANY

3.

NOTE: This step is only necessary when installing a new component.

Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Configuration - System Operation and Component Description .

4.

Reprogram the PATS. Carry out the Parameter Reset procedure. Refer to: Anti-Theft Security Access and Key Programming - Scan Tool .

5.

After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.