Common Specifications & Procedures
COMMON SPECIFICATIONS & PROCEDURES FUSION (HYBRID/ENERGI)
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS - 2.0L DURATEC - HYBRID (96KW/130PS) | ||
| Torque | Refer to appropriate component in REMOVAL AND INSTALLATION | ||
| Axle Nut/Hub Nut | |||
| Front | 148 Ft. Lbs. (200 N.m) | ||
| Rear | 148 Ft. Lbs. (200 N.m) | ||
| Battery | SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF BRAKE SYSTEM PRESSURE BLEEDING |
||
| Disc Brakes | |||
| Front | SPECIFICATIONS | ||
| Rear | SPECIFICATIONS | ||
| Torque | |||
| Front | Refer to appropriate component in REMOVAL AND INSTALLATION | ||
| Rear | Refer to appropriate component in REMOVAL AND INSTALLATION | ||
| Engine Cooling | |||
| General Service Specification | |||
| SPECIFICATIONS | |||
| Thermostat R & I | |||
| THERMOSTAT | |||
| Water Pump R & I | |||
| COOLANT PUMP | |||
| Engine Mechanical | |||
| Compression | SPECIFICATIONS | ||
| Oil Pressure (Hot @ 2000 RPM) | 29-60 psi (200-414 kPa) | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | Refer to appropriate component in REMOVAL AND INSTALLATION procedure. | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | For tightening sequence, refer to FLYWHEEL Stage 1: 37 lb.ft (50 Nm) Stage 2: 59 lb.ft (80 Nm) Stage 3: 83 lb.ft (112 Nm) |
||
| Fuel System | |||
| Fuel Filter Location | Located in fuel tank as part of the fuel pump module. | ||
| Fuel Filter R & I | FUEL PUMP AND SENDER UNIT | ||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification | Engine running 2.0L 50.8-65.3 psi (350-450 kPa) |
||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE CHECK | ||
| Ignition | |||
| Firing Order & Cylinder Identification | 1-3-4-2 FIRING ORDER & CYLINDER IDENTIFICATION |
||
| Ignition Wires (Routing) | Engines have coil-on-plug ignition. | ||
| Spark Plugs | |||
| Type | AYFS 32Y R | ||
| Gap | 0.051 in (1.3 mm) | ||
| Torque | 106 In. Lbs. (12 N.m) | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | ||