BCMB DTC Chart
WARNING: This page is about a different car, the 2018 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B1060:11 | Seat Headrest Motor Output: Circuit Short To Ground | REFER to: Rear Seats . |
| B1060:15 | Seat Headrest Motor Output: Circuit Short To Battery or Open | REFER to: Rear Seats . |
| B106E:23 | Headrest Down Switch: Signal Stuck Low | REFER to: Rear Seats . |
| B1298:23 | Steering Column Adjust Up Switch | REFER to: Steering Column . |
| B1299:23 | Steering Column Adjust Down Switch: Signal Stuck Low | REFER to: Steering Column . |
| B12A1:23 | Steering Column Adjust Out Switch: Signal Stuck Low | REFER to: Steering Column . |
| B12A2:23 | Steering Column Adjust In Switch: Signal Stuck Low | REFER to: Steering Column . |
| B1375:11 | Steering Column Tilt Motor: Circuit Short To Ground | REFER to: Steering Column . |
| B1375:15 | Steering Column Tilt Motor: Circuit Short To Battery or Open | REFER to: Steering Column . |
| B137E:11 | Steering Column Telescope Motor: Circuit Short To Ground | REFER to: Steering Column . |
| B137E:15 | Steering Column Telescope Motor: Circuit Short To Battery or Open | REFER to: Steering Column . |
| B1C33:29 | Steering Column Tilt Feedback Signal: Signal Invalid | REFER to: Steering Column . |
| B1C35:29 | Steering Column Telescope Feedback Signal: Signal Invalid | REFER to: Steering Column . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | Go To PINPOINT TEST B |
| U0208:00 | Lost Communication With "Seat Control Module A": No Sub Type Information | Go To PINPOINT TEST C |
| U0294:00 | Lost Communication With Powertrain Control Monitor Module: No Sub Type Information | Go To PINPOINT TEST D |
| U1000:00 | Solid State Driver Protection Active -Driver Disabled: No Sub Type Information | GO To PINPOINT TEST A |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. INSTALL As-Built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. |
| U3000:49 | Control Module: Internal Electronic Failure | ADDRESS all other Diagnostic Trouble Codes (DTCs) first. CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If no BCM Diagnostic Trouble Codes (DTCs) are retrieved, INSTALL a new BCMB. Refer to: Body Control Module B (BCMB) . |