Power Roof Opening Panel Initialization
For information on Ford Color Coded Illustrations refer to OEM COLOR CODING
Initialization
WARNING:
Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.
NOTE:
The roof opening panel motor must be initialized when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel glass (rear fixed glass or front sliding) has been removed, or if the roof opening panel shield or frame has been removed.
NOTE:
Carrying out the initialization will initialize both the roof opening panel glass motor and the shield motor.
- Make sure all doors are closed, the engine is running and make sure both map lights are off. Press and release the door function switch on the overhead console to disable the 30-second PWM amp-down of the lights that takes place when the doors are opened. An orange/amber backlight shows it's active.
-
NOTE: Carrying out this step will put the overhead console in diagnostic mode.
- Press the left map light switch once turning the lamp on.
- Without pausing, press and release the right map light switch four times ending with the lamp off.
- Without pausing, press and release the left map light switch once turning the lamp off.
- Place the roof opening panel glass in the fully closed position.
- Press and hold the sliding glass close switch until the shield moves to the fully closed position and then to the fully open position, then release the switch and immediately begin step 5.
- The sliding glass will move to the hard stop (after approximately 10 seconds), stall and then move back to the closed position.
- Then the shield will move forward to the hard stop, stall and then retract to the fully open position.
- Wait 2 seconds and then press and hold the sliding glass close switch until the shield moves to closed position, then release the switch.
- The sliding glass will move to the fully open position, and then return to the closed position.
- Then the shield will return to the closed position.
- Verify proper one-touch open and close operation.