Symptom Chart: Climate Control - Electronic Manual Temperature Control (EMTC)
NOTE:
Some Powertrain Control Module (PCM) Diagnostic Trouble Codes (DTCs) may inhibit Air Conditioning (A/C) operation. If any Powertrain Control Module (PCM) Diagnostic Trouble Codes (DTCs) are retrieved, diagnose those first. Refer to the appropriate Powertrain Control Module (PCM) Diagnostic Trouble Code (DTC) Chart.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Condition | Possible Sources | Actions |
|---|---|---|
| A module does not communicate with the diagnostic scan tool | Fuse(s) Wiring, terminals or connectors |
REFER to: Communications Network |
| Externally Controlled Variable Displacement Compressor (EVDC) Performance Check with or without DTC P06A0 | Refer to Pinpoint Test | GO to Pinpoint Test M |
| Reduced outlet airflow | Refer to Pinpoint Test | GO to Pinpoint Test S |
| The air inlet door is inoperative | Refer to Pinpoint Test | GO to Pinpoint Test C |
| Incorrect or erratic direction of airflow from outlets | Refer to Pinpoint Test | GO to Pinpoint Test D |
| Insufficient, erratic or no heat | Refer to Pinpoint Test | GO to Pinpoint Test E |
| The A/C is inoperative with no Diagnostic Trouble Codes (DTCs) | Refer to Pinpoint Test | GO to Pinpoint Test F |
| The A/C is always on -- A/C mode always commanded ON | Refer to Pinpoint Test | GO to Pinpoint Test G |
| Temperature control is inoperative/does not operate correctly | Refer to Pinpoint Test | GO to Pinpoint Test H |
| The blower motor is inoperative | Refer to Pinpoint Test | GO to Pinpoint Test I |
| The blower motor does not operate correctly | Refer to Pinpoint Test | GO to Pinpoint Test J |
| Insufficient A/C cooling | Refer to Pinpoint Test | GO to Pinpoint Test R |
| A/C pressure relief valve discharging | Refer to Pinpoint Test | GO to Pinpoint Test P |
| A/C System NVH | Refer to Pinpoint Test | GO to Pinpoint Test Q |
| Climate control does not operate only when remote start is used | IPC information display settings Non-Ford approved remote start system installed |
VERIFY Remote Start - Message Center Set To Auto, or Remote Start - Message Center Set To Last User Settings. REFER to: Climate Control System - Vehicles With: Electronic Manual Temperature Control (EMTC) - System Operation and Component Description
. VERIFY module communications network operation. DIAGNOSE Diagnostic Trouble Codes (DTCs) if present. |