Frame Members-Rear Frame Section: Installation
-
NOTE: Verify dimensional accuracy before performing any welding operations.
Install the new rear frame section into the mid rear section of the frame and tack weld the frame rails..
- Perform a final measurement, then final weld the new rear section to the mid rear section on all overlap joints on both sides. Use the General Equipment: MIG/MAG Welding Equipment
- Metal finish the joint area typical metal finishing techniques.
- Metal finish the joint area typical metal finishing techniques.
- Refinish using a Ford approved paint system.
- Restore corrosion protection.
-
NOTE: To avoid damage to the spare tire winch when installing the spare tire, DO NOT exceed 200 RPM if using power tool equipment.
Install the following items:
- As equipped. Refer to: Fuel Tank Filler Pipe
- As equipped. Refer to: Muffler and Tailpipe
- Refer to: Shock Absorber and Spring Assembly
- Refer to: Rear Bumper