Fuel Pressure Sensor - Installation

INSTALLATION

WARNING: No sparks, open flames or smoking. Risk of poisoning from inhaling and swallowing fuel. Risk of injury to eyes and skin from contact with fuel. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing.

NOTE: The installation of the pressure sensor must be performed out of vehicle so that the sensor can be tightened properly.

1. Install the fuel rail pressure sensor and new seal. Tighten to 22 Nm (194 lbs. in.).
2. Install the fuel rail.
3. Connect rail sensor electrical connector.
4. Connect negative battery cable.
5. Start engine, allow to warm, turn engine off and inspect for leaks.
6. Install engine cover.