Anti-Lock Brake System Module - Removal

REMOVAL






CAUTION: When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 in.) before removing ABM. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement. Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.

NOTE: If the ABM module is being replaced with a new ABM module it must be reprogrammed with the use of a scan tool.

1. Remove the negative battery cable from the post by the accelerator pedal.
2. Pull up on the ABM harness connector release and remove connector.
3. Remove the ABM screws (2).
4. Remove the ABM (1) from the HCU.