Section 7 (Power Steering General Servicing): Testing: Preparation
WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 1987 Jeep Wrangler, 1987 Jeep Wagoneer, 1987 Jeep Pickup, 1987 Jeep Grand Wagoneer, and 1987 Jeep Comanche. However, it is still accessible from the selected car via links, so may be relevant.
- With belt tension correct, disconnect power steering pump pressure hose. Keep hose end raised to prevent fluid loss. Connect pressure hose of gauge to power steering pump fitting. Connect other hose from valve side of tester to steering gear inlet.
- Open valve and run engine until fluid reaches normal operating temperature of 170°F (77°C). Check fluid level and add if necessary.