Keyless Entry Receiver: Testing and Inspection

The remote keyless entry receiver module must be programmed whenever it is being replaced or a new transmitter is used.

When programming the module, use the following steps:
1. Connect a fused jumper from BLK/WHT (450) wire to PPL (950) wire at ALDL connector C308. Both doors will LOCK and then UNLOCK.
2. Press the LOCK button on the transmitter to be used.
3. Remove jumper wire from connector C308. Module is now programmed for the transmitter.
4. Repeat steps 1 through 3 if programming for a second transmitter.