LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 1994 >> Forward Control 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Controls - Remove/Install/Overhaul) >> Powertrain Control Module (Pcm) >> Programmable Read-Only Memory (Prom) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programmable Read-Only Memory (Prom): Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure new PROM has same service number as old one. Place NEW PROM in PROM carrier, and position squarely over PCM PROM socket. Press on PROM carrier until PROM is firmly seated in PCM.
    NOTE: Ensure reference notches in PCM and PROM are properly aligned. If PROM is installed backwards and ignition is turned on, PROM will be destroyed.
  2. Install PROM access cover on PCM. Install PCM in vehicle. See INSTALLATION under CONTROL UNIT . Start engine, and ground DLC terminal "B". Watch for trouble Code 51 or 52.
  3. If this occurs, PROM is not fully seated in PCM, installed backwards, has bent pins, or is defective. If bent pins are cracked while straightening, replace PROM. If PROM is installed backwards or is defective, replace PROM.
scientia non olet · About LEMON Manuals