LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 1997 >> Jimmy 4D Utility, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless Entry System - Remote >> Programming Procedures >> Transmitter Reprogramming >> Without Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Without Scan Tool

  1. Ground terminal No. 4 (Black) to No. 8 (Black/White wire) of Data Link Connector (DLC) located under lower left side of instrument panel. Receiver will respond by locking and unlocking all doors and activating liftgate window release (if equipped) within 2 seconds. Press any button of first transmitter to be reprogrammed. Control module will respond by locking/unlocking all doors and activating liftgate window release (if equipped).
  2. Press any button of second transmitter to be reprogrammed (if equipped). Control module will again respond by locking/unlocking all doors and activating liftgate window release (if equipped). Remove ground from DLC terminals. Transmitter operation can be verified by locking and unlocking doors and automatically activating liftgate window release.


  1. With ignition switch in OFF position, hold down power unlock button on door panel. Turn ignition switch to ON position, then OFF. Turn ignition switch to ON position, then OFF a second time. Release power unlock button on door panel. Receiver will respond by locking and then unlocking all doors and unlatching rear window (utility vehicles only) to indicate programming mode.
  2. Hold down LOCK and UNLOCK buttons on transmitter for 15 seconds. Receiver should respond by locking then unlocking all doors and unlatching rear window (utility vehicles only).
  3. Repeat step 2) for each additional transmitter. All extra transmitters MUST be reprogrammed at this time. When a new transmitter is reprogrammed, old transmitters will be deactivated.
  4. Turn ignition to ON position to exit transmitter mode.
scientia non olet · About LEMON Manuals