LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2001 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> Steering >> Steering Linkage (Non-Rack & Pinion) >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Steering Linkage Components
    GM340481Courtesy of GENERAL MOTORS COMPANY
  1. Install the relay rod (9) to the vehicle.
  2. Install the relay rod (9) to the pitman arm ball stud (2).
  3. Install the relay rod (9) to the idler arm ball stud (1).
  4. Ensure the seal is on the stud.
    5. Fig 2: Seating The Idler Arm Tapers
    GM689037Courtesy of GENERAL MOTORS COMPANY
  5. Install the J 29193  or the J 29194 .
  6. Refer to Fastener Notice .

    Tighten the steering linkage installer in order to seat the tapers.

    Tighten 

    Tighten the steering linkage installer to 54 N.m (40 lb ft).

  7. Remove the J 29193  or the J 29194 .
  8. Install the new pitman arm prevailing torque nut.
  9. Install the new idler arm prevailing torque nut .

    Tighten 

    Tighten the nuts to 62 N.m (46 lb ft).

  10. Install the tie rod ends. Refer to Tie Rod Replacement .
  11. Install the steering damper to the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement .
  12. Install the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement .
  13. Lower the vehicle.
  14. Check the wheel alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals