Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stop Lamp Switch, Locknut And Brake Pedal Bracket

Courtesy of GENERAL MOTORS CORP.

Install the stoplamp switch (1) to the brake pedal bracket (3). Secure the stoplamp switch (1) using one locknut (2). Do not tighten.
Adjust the stoplamp clearance. Refer to Stop Lamp Switch Adjustment .

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the locknut (2) for the stoplamp switch (1).
Tighten: Tighten the locknut to 10 N.m (89 lb in).
Connect the stoplamp switch electrical connector.
Connect the negative battery cable.