Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the upper control arm.

Fig 1: Removing/Installing Upper Control Arm Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
Gently pry out on inner fender to access forward facing bolt.

Fig 2: Accessing Forward Facing Bolt
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the upper control arm mounting bolts.
Tighten: Tighten the upper control arm mounting bolts to 150 N.m (111 lb ft).
Install the battery tray, if removed. Refer to BATTERY TRAY REPLACEMENT in Engine Electrical.
Connect the ABS wheel speed sensor wiring harness to the upper control arm.

Fig 3: View Of ABS Harness
Courtesy of GENERAL MOTORS CORP.
Connect the upper control arm to the steering knuckle

Fig 4: View Of Upper Control Arm To The Steering Knuckle Pinch Bolt And Nut
Courtesy of GENERAL MOTORS CORP.
Install the upper ball joint to upper control arm pinch bolt and nut.
Tighten: Tighten the upper ball joint to upper control arm pinch bolt to 40 N.m (30 lb ft).
Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels
Lower the vehicle.
Check the front wheel alignment. Refer to WHEEL ALIGNMENT .