Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the cooling fan motor harness connectors X2 and X3 from the cooling fan control module.
- Connect a 30 A fused jumper between B+ and the cooling fan motor control circuit terminal 1. Connect a jumper wire between the cooling fan motor ground circuit terminal 2 and ground. Verify the cooling fan is activated at a high speed.
- If either fan does not operate, replace the appropriate cooling fan motor.
- If both of the cooling fans test normal, test or replace the cooling fan control module.
NOTE:
The following test must be performed on both cooling fans.