Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important

Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

Install the EBCM (2) on to the BPMV (1).
Install the new screws in the EBCM (2). Tighten the screws to 5 N.m (39 lb in) in an X-pattern.
Install or tighten the EHCU bracket mounting bolts (4). Tighten the EHCU bracket mounting bolts to 25 N.m (18 lb ft).
Connect the electrical connectors to the EBCM.
Lower the vehicle.
Connect the negative battery cable.
Revise the tire calibration using the Scan Tool Tire Size Calibration function.
Return to Diagnostic Starting Point - Anti-Lock Brake System .