LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: SDM Assembly And Fasteners
    GM819439Courtesy of GENERAL MOTORS CORP.
  1. Install the SDM assembly (1) into the vehicle, taking care to ensure that the connectors are pointing toward the rear of the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the three SDM fasteners (2).

    Tighten:  Tighten the fasteners to 18 N.m (13 lb ft).

  3. Install the SDM electrical connectors.
  4. Install the under seat duct.
  5. Install the center console and then install the rear console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 4 .
scientia non olet · About LEMON Manuals