LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1582 (Body Control System) >> Repair Instructions >> Body Control Module (BCM) Programming/RPO Configuration >> Setup New Body Control Module (BCM)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Setup New Body Control Module (BCM)

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: After the procedure is completed, the personalization settings of the BCM are set to a default setting. Inform the customer that the personalization must be set again.

Refer to Service Programming System (SPS) (Remote Procedure)   or SERVICE PROGRAMMING SYSTEM (SPS) (PASS-THRU PROCEDURE) or Service Programming System (SPS) (Off Board Remote Procedure) or Service Programming System (SPS) (Off Board Pass-Thru Procedure) in Programming.

IMPORTANT: After programming, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF for 10 seconds.
  2. Connect the scan tool to the data link connector.
  3. Turn the ignition ON with the engine OFF.
  4. Use the scan tool in order to retrieve history DTCs from all modules.
  5. Clear all history DTCs.
scientia non olet · About LEMON Manuals