LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1699 (Front Suspension System) >> Repair Instructions >> Shock Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock module to the shock tower and lower control arm.
    Fig 1: Removing/Installing Shock Module
    GM731555Courtesy of GENERAL MOTORS CORP.
  2. Install the shock module yoke to the lower control arm.
  3. Lower the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the shock module upper retaining nuts.

    Tighten:  Tighten the shock module upper retaining nuts to 45 N.m (33 lb ft).

    Fig 2: Removing/Installing Shock Module Retaining Nuts
    GM744327Courtesy of GENERAL MOTORS CORP.
  5. Raise the vehicle.
  6. Install the shock module yoke to lower control arm retaining nut.

    Tighten:  Tighten the shock module yoke to lower control arm retaining nut to 110 N.m (81 lb ft).

    Fig 3: Removing/Installing Shock Module Yoke Lower Mounting Nut
    GM744328Courtesy of GENERAL MOTORS CORP.
  7. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tire and Wheels.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals