Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the shock module upper retaining nuts.

Fig 1: Removing/Installing Shock Module Retaining Nuts
Courtesy of GENERAL MOTORS CORP.

NOTE: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.
Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tire and Wheels.
Remove the shock module yoke to lower control arm retaining nut.

Fig 2: Removing/Installing Shock Module Yoke Lower Mounting Nut
Courtesy of GENERAL MOTORS CORP.
Remove the shock module yoke from the lower control arm using J 24319-B .

Fig 3: Disconnecting Shock Module Yoke From Lower Control Arm

Courtesy of GENERAL MOTORS CORP.

Remove the shock module from the shock tower and lower control arm.

Fig 4: Removing/Installing Shock Module
Courtesy of GENERAL MOTORS CORP.