Throttle Actuator Control Module (5.3L): Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

If necessary, install the TAC module bracket (1) and nuts (2). Tighten the nuts to specification. See TORQUE SPECIFICATIONS . See Fig 3.
Install the TAC module (3) to the retaining bracket (1).
Snap the TAC module (3) into retaining tab.
Connect the engine harness electrical connector. See Fig 2.
Connect the I/P harness electrical connector. See Fig 1.
Install the bulk connector to the bracket.

Fig 1: Removing & Installing TAC Module (1 Of 3)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing & Installing TAC Module (2 Of 3)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing & Installing TAC Module (3 Of 3)

Courtesy of GENERAL MOTORS CORP.