LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Body Control System) >> Diagnostic Information and Procedures >> DTC B1001: Module Is Not Configured Properly >> Test Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Description

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 3:  If DTC B1001 is set as current, reprogram the module.
DTC B1001

Step Action Yes No
Connector End View Reference: Master Electrical Component List in Wiring Systems
1 Did you perform the Diagnostic System Check for the system exhibiting the symptom? Go to Step 2  Go to Control Module References  for the applicable Diagnostic System Check
2
  1. Install the scan tool.
  2. Turn On the ignition with the engine Off.
  3. Retrieve the DTCs.
Is the DTC retrieved as current?		 Go to Step 3  Go to Diagnostic Aids
3  Perform the programming or set up procedure for the module. Refer to Control Module References  for the proper procedure.
Does the DTC reset?		 Go to Step 4  System OK
4
IMPORTANT: Perform the programming or set up procedure for the replaced control module.
Replace the module. Refer to Control Module References  for applicable replacement procedure.Did you complete the replacement?		 System OK -
scientia non olet · About LEMON Manuals