LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Case - Servicing >> Removal & Installation >> Motor/Encoder >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation: Motor/Encoder: Removal

NOTE: The motor/encoder gasket does not have to be replaced if the motor/encoder is being removed from the transfer case for other service procedures. Replace the motor/encoder gasket only if damaged. If the motor/encoder is being replaced, a new gasket will come with the replacement motor/encoder.
  1. Raise and support vehicle.
  2. Remove the transfer case shield. See TRANSFER CASE SHIELD .
  3. Remove front drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in DRIVELINE/AXLES.
  4. Remove the motor/encoder electrical connector. See Fig 1.
  5. Remove the motor/encoder mounting bolts.
  6. Remove the motor/encoder assembly. See Fig 2.
  7. Remove the motor/encoder gasket.
Fig 1: Removing/Installing Transfer Case Motor/Encoder Electrical Connector
G00209684Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Transfer Case Motor/Encoder Assembly
G00209680Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals