Installation Procedure

IMPORTANT: Do not reuse the old mounting screws (1). Always install new mounting screws with the new EBCM.

IMPORTANT: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

Install EBCM (2) on to the BPMV (5).

Fig 1: Expanded View Of EBCM & BPMV
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the new screws (1) in the EBCM (2).
Tighten: Tighten the screws to 5 N.m (39 lb in) in an X-pattern.
Connect the electrical connectors to the EBCM.
Secure the module (1) to the frame bracket (3) and fuel pipe shield (2) with the two nuts (4).

Fig 2: View Of Fuel Pipe Shield Mounting Nuts
Courtesy of GENERAL MOTORS CORP.
Revise the tire calibration using the Scan Tool Tire Size Calibration function.
Return to Diagnostic System Check - ABS .