LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2005 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

IMPORTANT:
  • Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
  • Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
    Fig 1: Disc
    GM924286Courtesy of GENERAL MOTORS CORP.
  1. Connect the BPMV electrical connector to the EBCM.
    2. Fig 2: Removing EBCM From BPMV
    GM924291Courtesy of GENERAL MOTORS CORP.
  2. Install the EBCM to the BPMV.
    3. Fig 3: Removing EBCM To BPMV Mounting Screws
    GM924301Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the new screws (1) in the EBCM (2).

    Tighten:  Tighten the screws to 5 N.m (39 lb in) in an X-pattern.

    4. Fig 4: Identifying Chassis Electrical Connectors To EBCM
    GM924296Courtesy of GENERAL MOTORS CORP.
  4. connect the chassis electrical connectors to the EBCM.
  5. Lower the vehicle.
  6. Connect the negative battery cable.
  7. Revise the tire calibration using the Scan Tool Tire Size Calibration function.
  8. Return to Diagnostic Starting Point - Anti-Lock Brake System .
scientia non olet · About LEMON Manuals