Installation Procedure

Install the regulator to the door.

Fig 1: Installing Front Door Window Regulator
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the bolts to the window regulator.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Align the window to the regulator and install the bolts holding the window to the regulator.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Connect the wiring harness to the window motor assembly.
Install the water deflector. Refer to Water Deflector Replacement - Front Door .
Install the trim panel. Refer to Trim Panel Replacement - Side Front Door .
Lower the window. Inspect the window operation.