Removal Procedure

CAUTION: Refer to Cracked Window Caution .

IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

Open the liftgate.
Remove the liftgate trim. Refer to Liftgate Trim Panel Replacement .
Disconnect the electrical connectors from the liftgate window defogger bus bar.
Remove the rear window wiper arm. Refer to Rear Window Wiper Arm Replacement .
Remove the rear spoiler. Refer to Rear Spoiler Replacement .
CAUTION: Refer to Defroster Outlet Caution .
Cover the following parts to protect from broken glass:
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting
CAUTION: Refer to Glass and Sheet Metal Handling Caution .

Fig 1: Separating Urethane Adhesive From Window
Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Keep the cutting edge of the tool against the window.
Remove the window from the urethane adhesive.
- Leave a base of urethane approximately 2 mm (0.078 in) on the pinch-weld flange.
- The only suitable lubrication is clear water.
- Use J 24402-A , J 39032 or equivalent in order to remove the window. See Special Tools .
Fig 2: Separating Bottom Of Window From Urethane Adhesive
Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Keep the cutting edge of the knife/tool against the window. Do this from inside the vehicle.
If necessary, use a long utility knife or similar tool to remove the bottom corners of the window from the urethane adhesive.

Fig 3: View Of Liftgate Window

Courtesy of GENERAL MOTORS CORP.

With the aid of an assistant, remove the window (1) from the vehicle.