Test Description
WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 2: Use the scan tool to check the normal state of the Traction Off control.
- 3: Ensures that the instrument cluster can operate the Traction Off indicator.
Traction Off Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Antilock Brake System Connector End Views , Displays and Gages Connector End Views or Data Communication Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Step 3 | Go to Step 10 |
| 3 |
|
Go to Step 4 | Go to Step 11 |
| 4 |
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 5 |
| 5 |
|
Go to Step 9 | Go to Step 6 |
| 6 | Test the signal circuit of the traction control switch for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 16 | Go to Step 7 |
| 7 | Test the ground circuit of the traction control switch for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 16 | Go to Step 8 |
| 8 | Inspect for poor connections at the harness connector of the rear integration module (RIM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 16 | Go to Step 12 |
| 9 | Inspect for poor connections at the harness connector of the traction control switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 16 | Go to Step 13 |
| 10 | Inspect for poor connections at the harness connector of the electronic brake control module (EBCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 16 | Go to Step 14 |
| 11 | Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 16 | Go to Step 15 |
| 12 | Replace the RIM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 16 | - |
| 13 | Replace the traction control switch. Refer to Electronic Traction Control Switch Replacement (Left Hand Drive) or Electronic Traction Control Switch Replacement (Right Hand Drive) . Did you complete the replacement? |
Go to Step 16 | - |
| 14 | Replace the EBCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 16 | - |
| 15 | Replace the IPC. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 16 | - |
| 16 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |