Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Theft Deterrent Control Module

Courtesy of GENERAL MOTORS CORP.

Install the theft deterrent control module onto the ignition lock cylinder case assembly.
CAUTION: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
Connect the connector to the theft deterrent control module.
If necessary, connect the connector to the ignition lock cylinder case.
Install the lock cylinder. Refer to Ignition Lock Cylinder Replacement.
Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement.
Enable the SIR. Refer to SIR Disabling and Enabling.
Program the theft deterrent system. Refer to Control Module References.