Door Lock Control Module Scan Tool Information (Driver Door Module)

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Driver Door Module Scan Tool Data Parameters

Parameter	System State	Expected Value	Description
Operating Conditions: Ignition ON
Battery Voltage Signal	-	Varies	This displays Volts. This is the current battery voltage signal.
Deadbolt Actuator Command	-	Idle	The scan tool displays Idle, Lock, Unlock or Invalid. This is the state of the deadbolt actuator.
Door Ajar Switch	-	Door Closed	The scan tool displays Door Ajar or Door Closed. This is the state of the door ajar switch.
Door Open Switch	-	Closed	The scan tool displays Open or Closed. This is the state of the door open switch.
Door Cylinder Switch	-	Idle	The scan tool displays Idle, Lock, Unlock or Invalid. This is the state of the door cylinder switch.
Door Switch Backlight Command	-	Varies	This displays %. This is the commanded door switch backlighting dimming percentage.
Driver Door Handle	-	Inactive	The scan tool displays Active or Inactive. This is the state of the driver door handle.
Driver Mirror Heater	-	Inactive	The scan tool displays Active or Inactive. This is the state of the driver mirror heater.
Driver Mirror Horizontal Position	-	Varies	This displays Volts. This is the current driver mirror horizontal position measured in volts.
Driver Mirror Motors Command	-	Idle	The scan tool displays Idle, Fold Out, Fold In, Left, Right, Down or Up. This is the commanded state of the driver mirror motors.
Driver Mirror Vertical Position	-	Varies	This displays Volts. This is the current driver mirror vertical position measured in volts.
Exterior Courtesy Lamp Command	-	Varies	This displays %. This is the commanded exterior courtesy lamps dimming percentage.
Exterior Courtesy Lamp Status	-	Off	The scan tool displays On or Off. This is the state of the exterior courtesy lamps.
LF Latch Solenoid Command	-	Inactive	The scan tool displays Active or Inactive. This is the state of the driver front latch solenoid.
Lock Indicator Command	-	Varies	This displays %.
Lock Switch Indicator Command	-	Off	The scan tool displays On or Off. This is the state of the lock switch indicator.
VIN Learned	-	Yes	The scan tool displays Yes or No. Yes is displayed if the vehicle identification number (VIN) is learned.
VIN Message Received	-	Yes	The scan tool displays Yes or No. Yes is displayed if the vehicle identification number (VIN) message is received.
Window Motor Command	-	Idle	The scan tool displays Idle, Up, Down or Active. This is the commanded state of the window motor.
Window Normalization	-	Varies	The scan tool displays Yes or No.

Driver Door Module Scan Tool Output Controls

Output Control	Description
Disable DTC(s)	This output control is used to disable DTCs in the module.
Door Deadbolt Lock/Unlock	This output control is used to command the door deadbolt.
Door Switch Backlight	This output control is used to command the door switch backlighting.
Driver Mirror Horizontal Motor	This output control is used to command the driver mirror horizontal motor.
Driver Mirror Vertical Motor	This output control is used to command the driver mirror vertical motor.
Driver Window Motor	This output control is used to command the driver window motor.
Exterior Courtesy Lamp	This output control is used to command the exterior courtesy lamps.
LF Latch Solenoid	This output control is used to command the driver front latch solenoid.
Lock Switch Indicator	This output control is used to command the lock switch indicator ON or OFF.
Mirror Fold	This output control is used to command the mirror fold.
Mirror Heater	This output control is used to command the mirror heater ON or OFF.