Ignition Control Module: Service and Repair

IGNITION CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the air cleaner outlet resonator.
2. Disconnect the ignition coil driver electrical connector (3).
3. Remove ignition control module (2) screws.
4. Remove the ignition control module (2) and heat sink (3).

INSTALLATION PROCEDURE




1. Position the ignition control module (2) and heat sink (3).

NOTE: Refer to Fastener Notice.

2. Install ignition control module (2) screws.

Tighten the screws to 3.5 N.m (31 lb in).

3. Connect the ignition coil driver electrical connector (3).
4. Install the air cleaner outlet resonator.
5. Refer to Control Module References for programming and setup information. Programming and Relearning