LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2007 >> Sierra Classic 2500 2WD V8-8.1L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Relays and Modules - Computers and Control Systems >> Electronic Throttle Control Module >> Service and Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronic Throttle Control Module: Service and Repair



ELECTRONIC THROTTLE ACTUATOR CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the connector position assurance (CPA) retainer (1).
2. Disconnect the instrument panel (I/P) harness electrical connector (2).




3. Disconnect the engine wiring harness electrical connector (1).




4. Remove the throttle actuator control (TAC) module nuts.
5. Remove the TAC module.




6. If equipped with a regular production option (RPO) ML6 manual transmission, unsnap the TAC module from the bracket.




7. If equipped with a RPO ML6 manual transmission, remove the TAC module bracket nuts.
8. Remove the TAC module bracket, if necessary.

INSTALLATION PROCEDURE




1. If equipped with a RPO ML6 manual transmission, install the TAC module bracket, if necessary.

NOTE: Refer to Fastener Notice.

2. Install the TAC module bracket nuts.

Tighten the nuts to 9 N.m (80 lb in).




3. If equipped with a RPO ML6 manual transmission, snap the TAC module to the bracket.




4. Install the TAC module.
5. Install the TAC module nuts.

Tighten the nuts to 9 N.m (80 lb in).




6. Connect the engine wiring harness electrical connector (1).




7. Connect the I/P harness electrical connector (2).
8. Install the CPA retainer (1).
9. Refer to Control Module References for programming and setup information. Programming and Relearning
scientia non olet · About LEMON Manuals