LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2011 >> Canyon 4D Pickup, 2.9 9 >> Repair and Diagnosis >> Engine Performance >> System >> Data Communications System >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of BCM
    GM1283835Courtesy of GENERAL MOTORS CORP.
  1. Position the BCM to the vehicle.
  2. Attach the BCM to the hinge pillar with the integral tab.
  3. Install the 2 fasteners retaining the BCM to the hinge pillar.
    4. Fig 2: View Of Detached Body Wiring Harness Electrical Connector
    GM1283832Courtesy of GENERAL MOTORS CORP.
  4. Install the fastener retaining the body wiring harness electrical connector to the BCM.
    5. Fig 3: View Of Body Wiring Harness Electrical Connector
    GM1283827Courtesy of GENERAL MOTORS CORP.
  5. Connect the body wiring harness electrical connector (1) to the BCM.
  6. Connect the remote control door lock receiver antenna wire to the BCM.
    7. Fig 4: View Of I/P Wiring Harness Electrical Connector
    GM1283829Courtesy of GENERAL MOTORS CORP.
  7. Connect the I/P wiring harness electrical connector (1) to the BCM.
  8. Install the right front hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side .
  9. If installing a replacement BCM, program the BCM. Refer to Control Module References .
scientia non olet · About LEMON Manuals