LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2012 >> Yukon Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1128 (Keyless Entry System & Remote Functions) >> Diagnostic Information and Procedures >> Electronic Key Not Detected >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the console passive antenna.
  2. Install a DMM between the signal circuit terminal A and the low reference circuit terminal B. Set the DMM to capture AC voltage using the MIN MAX function.
  3. Attempt to start the vehicle. Verify the DMM captured an AC voltage signal.
    • If an AC voltage was not captured, test the signal circuit and the low reference circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the RCDLR.
  4. If all circuits test normal, test or replace the console passive antenna.
scientia non olet · About LEMON Manuals