Replace and Program Control Module
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 GMC Sierra 3500 HD, 2016 GMC Sierra 2500 HD, 2016 GMC Sierra 1500, 2016 Chevrolet Silverado 3500 HD, and 2016 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, under Select Controller, select K182 Parking Assist Control Module.
- On the SPS Supported Controllers screen, under Select Function / Sequence, select Programming and follow on screen instructions.
- On the SPS Supported Controllers screen, under Select Function / Sequence, select Configuration and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.